- if knownNodes grows to 20000, instead of ignoring new nodes, forget
the 1000 oldest ones
- drop connection after sendaddr if too many connections, even if it's
an outbound one
- if maximum total connections are lower than maximum outbound
connections, active bootstrap provider mode
- in this mode, check all addresses received before announcing them
- so basically it only annouces those addresses it successfully
connected to
- I can't get the dynamic loading to work on OSX in frozen mode
- I think that if someone wants to build a frozen executable with custom
messagetypes modules, he can edit the file
- so now it lists the existing types manually (for frozen mode only)
- maxtotalconnections = maximum number of total full connections
(incoming + outgoing) the node will allow. Default 200 as it was.
- maxbootstrapconnections = number of additional (to total) connection
that will act in bootstrap mode, closing after sending the list of
addresses. Default 20 as it was.
- maxaddrperstreamsend = initial address list maximum size, per
participating stream. Default 500. Child streams get half. The
response is chunked into pieces of max. 1000 addresses as that's the
protocol limit.
- on OpenBSD, you can't have a socket that supports both IPv4 and IPv6.
This allows handling for this error, and then it will try IPv4 only,
just like for other similar errors.
- there were reports of errors in FreeBSD (I could only reproduce some)
and Gentoo without IPv4 support (I don't have a VM for testing ready)
- adds an exception handler for double task_done in case sender thread
has to close prematurely (I saw this triggered on FreeBSD 11)
- listening socket opening error handler was broken (triggered if you
can't open a socket with both IPv4 and IPv6 support)
- error handler for socket.accept. Reported on FreeBSD 10.3
- fixes#854
- TTL to chans shouldn't be too low so the UI gives a feedback
- warning when sending wouldn either require a lot of refactoring or
wouldn't have good usability
- don't do subprocess in SafeHTMLParser, it doesn't work in frozen mode
and an attempt to fix it would take too much refactoring and I'm not
even sure it would work
- instead, make it handle broken unicode correctly
- I think the previous reports of freezes were caused by trying to
interpret data as unicode, causing a crash
- it does about 1MB/s on my machine, so a timeout is not a big problem
Peter Šurda
PyBitmessage Translations
Dmitri Bogomolov
Justin Ramos